Advertisement
8. Torque drive pinion nut to specifications.
13. Set master gauge VW 385/30 to pinion setting
(82.41 mm in example) and place on master
mandrel. Set dial gauge (3 mm range) at zero
with 1 mm preload.
9. Make sure that the taper roller bearing
outer races fit tight in transmission case
and side. cover.
10. Set adjusting ring of universal gauge
VW 385/1 to distance "a".
14. Remove master gauge after setting
dial gauge.
15. Place gauge plate VW 385/17 on
head of drive pinion.
about 58 mm
11. Slide centering discs 9109 on gauge.
Screw in gauge plunger VW 385/14
with 30 mm dial gauge extention
VW 385/56.
12. Install taper roller bearing from
differential, or spare taper roller
bearing. on centering discs.
39-13
Adjusting Drive Pinion
Printed in Germany -IV.
1981
Advertisement
