Advertisement
Mech .gear
-shift
system
-gears,
shafts
REMOVING
AND
INSTALLING
INSTRUCTIONS
Removing
3.
Pull off cylindrical rollex bearing
toward front.
1. Loosen nuts for drive pinion and drive shaft.
Place reverse gear shaft or other corresponding
shaft in bore of gear housing. Slide on reverse
gear II as illustrated and place in 4th.
4. Remove all parts from drive pinion and
drive shaft, and mark needle bearings for
installation (also refer to 'Dismantling and
Assembling Drive Pinion and Drive Shaft").
2. Unscrew reverse gear lock plug.
5. Loosen clamp nuts and remove drive
pinion and drive shaft.
Note
Plug is under heavy spring tension. Prevent
spring and plug from jumping away when
unscrewing (danger of injuries).
6. Remove shims. Note number and thickness
for-installation.
35-5
Dismantling and Assembling Change Gear
Printed in Germany
Advertisement
