Advertisement
Clutch,
Control
REMOVING
AND
INSTALLING
Removing
Note
1. Hold flywheel with toothed segment P 201 a
and spacer sleeve. Make sure that spacer sleeve
fits engine with adequate clearance.
Clutch linings cannot be replaced.
If applicable, the entire disc is to be replaced.
2. Loosen bolts holding clutch pressure plate to
flywheel evenly and diagonally one or two
threads, until the spring pressure stops (pre-
vents distortion on clutch pressure plate).
5. Check disc with lining for lateral runout.
Permissible lateral run out on 225 mm .
diameter is max. 0.6 mm.
CHECKING
CLUTCH
DISC
1. Check teeth. The clutch disc must move
easily in axial direction on drive shaft with-
out radial play.
2. Check rivets. Replace clutch disc if in
doubt.
3. Check clutch lining. If clutch lining has oil
spots, is burnt, torn or worn at spots, install
a new disc.
4. Check lining thickness. Thickness of di'lc
+
with riveted lining (no tension) is 10.1 -
0.3 mm. Wear limit (no tension) is 8.5 mm
for symmetrical wear.
Printed in Germany
Removing and Installing Clutch Disc
30
-4
Advertisement
