Advertisement
Manual
Transmission.
Controls.
Case
DISASSEMBLING
AND
ASSEMBLING
INSTRUCTIONS
Disassembling
Note
1. Take tension off of spring to remove the
release lever. This is done by pressing the
release lever toward the front transmission
cover with an appropriate tool.
Only mount the adjusting lever after the engine/
transmission assembly has been installed in car.
Adjust clutch, see Repair Manual 911, Main
Group 7, Page 2.1 -2/3.
Note
The spring will snap back on its own when
reaching the "point of return".
Assembling
1. Drive in lever shaft bushings with Special
Tool P 375 until they are positioned correctly
(see drawing.
Disassembling and Assembling Transmission Case
34
-14
c
Printed in Germany
-II.
1976
Advertisement
