DISASSEMBLING
AND
ASSEMBLING
INSTRUCTIONS
Disassembling
2. Insert lockwasher and install snap ring so that
the opening is well located in the area of
the guide groove.
1. Lift out snap ring with a small screwdriver
and remove lockwasher.
MODIFICATIONS
-1977
MODELS
Assembling
Synchronization for 1st and 2nd gears has
been changed.
1. Insert synchronizing ring on clutch body in
correct position, and install lock, stop and
lock straps (or just one lock strap for 1st
gear) .
1. Synchronizer parts for 1st gear.
2. Synchronizer parts for 2nd gear.
Synchronization parts for 2nd, 3rd and 4th gear
3. Installed diameter of synchronizing rings
has not been changed (see Page 35 -26) .
Synchronization parts for 1st gear
Disassembling and Assembling Synchronization
35-25
Printed in Germany -ll,
1976