Remote Control Operation - Sharp FP-R65CX Operation Manual

REMOTE CONTROL OPERATION

POWER ON/OFF Button
• When you press the
POWER ON/OFF Button,
a short beep will sound
and operation will start in
AUTO Mode.
• Unless unplug the power
cord, the operation starts
in the previous mode the
unit was operated in.
• To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the
air.
Manual (Fan Speed) Button
The fan speed can be
switched among Silent,
MEDIUM and MAX settings.
LIGHTS ON/OFF Button
Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.
Plasmacluster Ion Mode Selections
ION AUTO
When pressed, the unit will switch between Clean
Mode and the Ion Control Mode automatically de-
pending on the amount of impurities in the air as
detected by the dust and odour sensors. Clean
Mode will operate for 1 minute when the Auto func-
tion is selected. (SENTINEL Operation Indicator
light turns on.)
ION CONTROL
When pressed, the unit will constantly operate
in Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• Lights ON/OFF
Plasmacluster Ion mode
selections
• ION AUTO
• CLEAN
• ION CONTROL
• ION OFF
Transmitter
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
• The indicator light shows the
remaining time.
• The unit will stop operation when
the timer is up.
Pollen Mode Operation
Button
See Page E-12
CLEAN
When pressed, the unit will constantly
operate in the Clean Mode, in which
the same numbers of positive and
negative ions are discharged. The
Plasmacluster Indicator Light is
blue.(SENTINEL Operation Indicator
light turns on.)
ION OFF
The generation of ions will stop and
the Plasmacluster Indicator Light
will go out.
E-13
1 hour 4 hours
Cancel