Comfort Glow CDVBN(A), CDVBP(A) Owner's Operation And Installation Manual page 6

CAST IRON STOVE AND BURNER SYSTEM
CAST IRON STOVE
AND DIRECT-VENT
BURNER SYSTEM
ASSEMBLY
Continued
8. Fasten each leg to stove with four (4)
M8 x 1.25 - 20mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure 9, page 5 and
Figure 10). Use an adjustable wrench
or a 12mm socket.
9. Fasten stove bottom to stove with four
(4) M6 x 1 - 25mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure 9, page 5 and
Figure 10). Use an adjustable wrench
or a 10mm socket.
Bolt
Leg
Figure 10 - Attaching Stove Legs
Washers
Bolt
Stove Bottom
Figure 11 - Attaching Stove Bottom
CDVBN(A) AND CDVBP(A)
10. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Figure
9, page 5 and Figure 10). Use an adjust-
able wrench or a 12mm socket to fasten
step bolt. Tighten step bolt until snug.
Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-
55mm with two M8 hex nuts) into
threaded hole on stove body (see Fig-
ure 9, page 5). Use an adjustable
wrench or a 12mm socket. The catch
bolt has two hex nuts attached to it
(see Figure 13). The top nut is a bolt
stop and the bottom nut is for door
leveling adjustment.
12. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
13. Carefully lift stove back up on its four
attached legs.
14. Set top grate into stove top.
Stove
Door
Door
Bottom Of
Hinge
Stove Unit
Step
Bolt
Figure 12 - Attaching Stove Door
Bottom Of
Stove Unit
Threaded
Hole
Bolt
Shoulder
Stove Bottom
6
Door Claw
Door
Figure 13 - Catch Bolt and Door Claw
Orientation
INSTALLING DIRECT-VENT
BURNER SYSTEM INTO
STOVE BODY
1. Carefully lift burner system and place
into stove body from the rear of stove.
2. Using screws provided, attach burner
system to back of stove.
Burner
System
Cast Iron
Stove Body
Figure 14 - Installing Burner System Into
Cast Iron Stove Body
Bolt Stop
Adjusting Nut
Catch Bolt
Screw
105501