Table of Contents
Advertisement
5. Grasp the retention pin on the front-panel assembly and gently pull it up until
6. Remove the assembly from the server.
7. To replace the front-panel assembly, reverse the previous steps.
Power backplane
Complete the following steps to remove the power backplane.
Note:
1. Turn off the server.
2. Disconnect all power cords and external cables from the back of the server.
3. Remove the server cover (see "Removing the top cover (all models)" on page
4. Remove the power supplies (see "Installing a hot-swap power supply" on page
5. Disconnect the cables that are attached to the power backplane.
6. Unlock the shuttle latch (see the illustration at step 7 on page 76) and pull the
Note: The illustrations in this document might differ slightly from your hardware.
the assembly releases.
v Read "Before you begin" on page 39.
v Read the safety notices at "Safety information" on page 167.
v Read "Handling electrostatic discharge-sensitive devices" on page 170
49).
96).
shuttle back to expose the power backplane.
Chapter 5. Service replaceable units
121
Advertisement
Table of Contents
