Completing The Installation - IBM XSERIES 255 TYPE 8685 Hardware Maintenance Manual And Troubleshooting Manual

10. Reconnect the internal cables that you disconnected.
11. Reinstall the server cover (see "Installing the top cover and bezel" on page
12. Reconnect all power cords and external cables and power cords that you
13. Start the Configuration/Setup Utility program and set configuration parameters

Completing the installation

To complete your installation, you must reinstall the server cover, reinstall the bezel,
reconnect all the cables that you disconnected earlier and, for certain options, run
the Configuration/Setup Utility program. Follow the instructions in this section.
Attention:
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
104
xSeries 255 Type 8685: Hardware Maintenance Manual and Troubleshooting Guide
7. Remove the battery:
a. Use one finger to slightly slide the battery toward the rear of the server
away from the back of the server. The spring mechanism behind the
battery will push it out toward you as you slide it toward the rear.
b. Use your thumb and index finger to pull the battery from under the battery
clip.
c. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
8. Insert the new battery:
a. Tilt the battery so that you can insert it into the front of the socket, under
the battery clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
9. If you did not remove any full-length adapters, continue with the next step. If
you removed any full-length adapters, you must reinstall the adapters. Move
the adapter locking lever to the locked (closed) position on the adapter-support
bracket. See "Working with adapters" on page 51 for additional information
about adapters.
105).
Note: You must wait approximately 20 seconds after you plug the power cord
of your server into an electrical outlet before the power-control button
becomes active.
disconnected; then, turn on the server and all attached devices.
as needed (see "Starting the Configuration/Setup Utility program" on page 11).
To maintain proper cooling and airflow, install the server cover before