Intel SRCS16 - RAID Controller Hardware User's Manual page 22

Table 3-1 defines the connectors on the RAID Controller SRCS16. Figure 3.1 provides the
layout of the controller. The Write Pending connector (J4) provides a LED signal that
indicates a write to disk has not been completed (dirty cache).
Table 3-1 Intel® RAID Controller SRCS16 Connector and Jumper Description
Jumpers and
Connectors Description
J1 32-bit PCI (open - 64-bit PCI)
J2 BIOS enable; (installed - BIOS disabled)
J3 UART serial I/O connector for test (not present)
J4 Connector for Write Pending Indication LED
J5 Serial I/O connector for Serial EPROM
2
J6 I C connector, used as the interface for the controller to communicate
with a storage enclosure processor in an enclosure arrangement
J7-J12 Port connectors (see Figure 3.1 for details)
J13 Mode 0 Select (closed - Mode 0)
J14 3.3 V load sharing (open - disable)
J15 Battery backup daughter card connector (not used)
J16, J17, JP1 Reserved for factory use
Figure 3.2 RAID Controller SRCS16 Board Layout
Reserved
[J17]
3.3V Load
Sharing [J14]
167 mm
Speaker
[U6]
Reserved
[J16]
Memory
Modules (5)
Battery
Connector
(not used) [J15]
Overview
Port 0 [J7]
Port1 [J8]
Port 2 [J9]
Port 3 [J10]
Port 4 [J11]
Port 5 [J12]
32-bit PCI [J1]
Write Pending Indication LED [J4]
BIOS Enable [J2]
Serial I/O Connector,
Serial EEPROM [J5]
UART Serial I/O [J3]
Serial I2C Connector
(Enclosure Management) [J6]
Mode 0 (IOP Reset) [J13]
56 mm
Default
Setting
Open
Open
Open
Open
Open
Open
Open
Open
Open
Open
–
22