After Using Tool - Hoover SteamVac FH50015 Owner's Manual

3-10
5. Before connecting tube (G) to clean-
er, make sure black tabs are extended
by pulling tan collar toward tube.
Open door on hood labeled "Stair/ uphol-
stery Cleaning Connection". Press round
solution tube connector onto round projec-
tion inside door. Press connector collar
down firmly to ensure that it is fully
connected.
6. The tank replaces in a hinge-like
instructions on pages 7 and 8.
3. Attach tool to end of hose.
4. Hose length may require that machine be
placed at the top of the stairs to clean
upper half of stairway and at bottom of
stairs to clean lower half.
To prevent machine from falling, use
extra caution when cleaning on stairs.
Do not place carpet cleaner on stairs.
Do not point tools toward people or
pets.
5. Dry hands and plug carpet cleaner into a
properly grounded outlet.
6. Turn carpet cleaner ON. If necessary, refer
12
3-11
manner. Position front of lid under tabs (H)
on front of tank. Rotate lid down onto tank.
Make sure lid is secure on all sides
before cleaning.
For full suction, it is important that
the recovery tank lid is properly
secured before cleaning.
Reverse procedure to remove hose
and solution tube.
Raise carpet cleaner handle to upright posi-
tion.
3-13

After using tool

1. Follow steps a and b for "After cleaning"
on page 9.
2. Rinse tool and hose by filling sink with a
small amount of water. Turn carpet cleaner
ON and pick up the water with the tool.
3. Drain hose by turning carpet cleaner ON
and holding end of hose up for several sec-
onds. Do not press trigger.
4. Disconnect carpet cleaner from
electrical outlet.
3-12
J
Replace recovery tank front panel (D). Slide
panel down until it snaps firmly in
place.
Read "Before you begin cleaning"
instructions on page 9.
1. Attach hose and solution tube as
instructed on page 11.
2. Fill clean solution tank with HOOVER
Carpet/Upholstery Detergent according to
3-14
to "Before using tool" section to remove air
from system.
7. Pre-spray the carpeted stair by holding
the tool about one inch above the carpet
and push it forward while pressing the trig-