Before Using Tool; After Using Tool - Hoover F5858910 Owner's Manual

3-9
3. Remove recovery tank front panel
(F) by sliding it straight up.
3-12
I
6. The tank replaces in a hinge-
like manner. Position front of lid
under tabs (I) on front of tank. Rotate
lid down onto tank.
Make sure lid is secure on all
sides before cleaning.
For full suction, it is important that
the recovery tank lid is properly
secured before cleaning.
Reverse procedure to remove
hose and solution tube.
Raise carpet cleaner handle to
upright
position.
3-14

After using tool

1. Follow steps a and b for "After
cleaning" on pages 10 and 11.
2. Drain suction hose by turning car-
pet cleaner ON and holding end of
hose up for several seconds. Do
not press trigger.
3-10
F
4. Replace panel with converter (G).
Slide converter halfway down open-
ing until it is firmly in place.
3-13
1. Attach tool to connector end of
hose by sliding it onto connector
until the tab (J) locks it securely.
Using your thumb, push forward
and up on the latch (K) to remove
tool as shown.
3. Disconnect carpet cleaner from
electrical outlet.
4. Drain solution tube by placing
round end in sink and raising nozzle
above your head. Press the trigger.
5. Proceed with steps c, d and e for
"After cleaning" on pages 10 and
11.
3-11
G
5. Before connecting tube (H) to
cleaner, make sure black tabs are
extended by pulling tan collar
toward tube.
Open door on hood labeled "Stair/
upholstery Cleaning Connection".
Press round solution tube connector
onto round projection inside door.
Press connector collar down firm-
ly to ensure that it is fully con-
nected.

Before using tool

It may be necessary to remove air
J
from the system ("prime the pump")
so the clean solution will flow to the
tool. Follow these steps:
1. Attach tool to hose and turn the
carpet cleaner ON.
2. Put the tool on a hard surface or
against your hand to block off the
suction.
K
3. Wait a few seconds (can take up
to 15 seconds). Then squeeze the
trigger and begin cleaning.
Follow the instructions on pages 14
and 15 for the appropriate cleaning
task.
3-15
Occasionally, debris may become
lodged inside of the hose at the
converter end (L). To clean out the
hose, lift bottom of converter clip
(M) with a screwdriver and remove
clip. Remove debris as shown.
H
L
M
Continued §
13