Tuner; Hdmi - Pioneer S-LX70C Operating Instructions Manual

Additional information
Problem
No sound is output when an
input function is selected.
No sound from surround
speaker.
Can't operate using the remote
control.

Tuner

Problem
Considerable noise in radio
broadcasts.
Auto tuning does not pick up
some stations.

HDMI

Symptom
No picture or sound.
No sound, or sound suddenly
ceases.
Remedy
• When playing back a source on the supplied HDD/DVD recorder, make sure that the
settings for Audio Out (page 155), and the HDMI Output under Audio Output Setting
(page 159) are all at their default values.
• If you're using the line input, make sure the component is connected correctly and the
volume level of your external component (i.e. a portable player, etc.) is adjusted (see
Connecting auxiliary components on page 40).
• Turn up the volume.
• No audio is output from the speakers connected to this unit if HDMI Mode is set to
Through Mode (page 43).
• No audio is output if a DVI component is connected via HDMI.
• Press MUTE on the remote control to turn muting off.
• Refer to Channel level setting on page 37 to check the speaker levels.
• Check that you haven't selected the Stereo mode (see Listening in surround sound on
page 31).
• Connect the speakers properly (refer to Connecting up on page 8).
• Verify the audio output and HDMI settings of your external component when connecting
an external component via an optical digital cable or HDMI cable.
• Replace the batteries (Putting the batteries in the remote control on page 26).
• Operate within 7 m, 30° of the remote sensor (Using the remote control on page 26).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• For operating the HDD/DVD recorder, make sure that the control cable and HDMI cable
are connected (page 13).
• For operating the other Pioneer component connected to the CONTROL OUT jack of this
receiver subwoofer, make sure that the control cable and either an HDMI or analog audio
cable are connected (page 42).
Remedy
• Connect the AM antenna (refer to Connecting up on page 8) and adjust the direction and
position for best reception. You may also connect an additional internal or external AM
antenna (refer to Connecting external antennas on page 42).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You
may also connect an outdoor FM antenna (see Connecting external antennas on page 42).
• Turn off other equipment that may be causing the noise or move it further away.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal.
For more sensitive tuning, connect an outdoor antenna.
Remedy
• This receiver is HDCP-compatible. Check that the components you are connecting are
also HDCP-compatible.
• Depending on the connected source component, it's possible that it will not work with
this receiver (even if it is HDCP-compatible).
• If the problem still persists when connecting your HDMI component directly to your
monitor, please consult the component or monitor manual or contact the manufacturer for
support.
• Check that the HDMI Mode setting is set to AMP Mode/Through Mode.
• If the component is a DVI device, use a separate connection for the audio.
• Check the audio output settings of the source component.
11
51
En