Basic Operation; Operating The Remote Control; Using The Lcd Touch Screen; Watching A Dvd - Pioneer S-LX70C Operating Instructions Manual

Before you start
04

Basic operation

This manual is split into two parts, one covering using the
receiver subwoofer, the other using the HDD/DVD
recorder. Below are some common operations and
where to find them explained in this manual.

Operating the remote control

The supplied remote control can control not only the
receiver subwoofer and HDD/DVD recorder, but also
other Pioneer products such as Blu-ray disc players, DVD
players, and plasma televisions.
To operate these components, orient the remote control
toward the display unit.
Operating the receiver subwoofer
• Press to display the RECEIVER screen.
RCV
The RECEIVER screen is shown on the remote control's
LCD screen, and the remote is switched to Receiver
mode.
Choosing and operating a source component
HDMI
1
1 2
Press to cycle through connected components.
The selected component changes, and the LCD screen
on the remote control changes to that of the appropriate
component.
• To select input for Digital 1, Digital 2, Analog, Front
Audio In, or iPod, press the LINE button until the
desired input function is shown on the display unit.
2 Choose the input source you are using when you
have selected HDMI 1 to HDMI 3 or LINE.
The LCD screen changes to that for the selected
component, and you can then operate the desired
component.
HDD/
DVR
HDMI input
28
En
RECEIVER
ADV F.S.
SURR
SURR SURR
TV LINE FM/AM
3
HDD/
BD DVD BD DVD
DVR
TV
EXIT EXIT
LINE input
• When the desired source cannot be found, or when
you have a component not manufactured by Pioneer
connected, press RCV to put the remote control into
Receiver mode. The input for this unit remains
unchanged.
Note
To temporarily control the receiver while listening to
audio from a connected component on this unit,
press RCV. The selected input will not change, and
the remote changes to Receiver mode. To return to
the previous operating mode, press RCV once more.

Using the LCD touch screen

Depending on the type of connected component you are
operating (such as an HDD/DVD recorder), there may be
multiple pages of information for the LCD touch screen.
When the component you would like to control is not
displayed, press PAGE to scroll to the page where the
component you would like to control is located.
• When no operations are carried out for over 10
seconds, the display on the LCD touch screen of the
remote control is automatically turned off. To have
the display shown once again, either touch the LCD
or press a button on the remote control.

Watching a DVD

Remember that when using the remote to control the
supplied HDD/DVD recorder, you should point the
remote towards the display unit, not the recorder itself.
RECEIVER
1 Switch on the receiver subwoofer.
2 Set the remote control to HDD/DVR mode.
The LCD screen changes to that for the HDD/DVD
recorder, and you can then operate the desired
component (see Choosing and operating a source
component above).
SOURCE
3 Switch on the HDD/DVD recorder.
TV
4 Switch on your TV.
Turn on your TV and make sure that it is set to the HDMI
video input.
HDD/
5 Press to select DVD.
DVD
OPEN/
6 Press on the HDD/DVD recorder to open
CLOSE
the disc tray.