Bernina 1300MDC User Manual page 95

Embroidery Settings 1
Embroidery Settings 2
«Adjust Reference Position» calibrates the
needle to the center of the embroidery hoop.
Adjusting can only be activated if the
embroidery module and the oval embroidery
hoop are attached. It is only necessary to
adjust the Reference Position once as the
same setting changes will apply to all the
hoops.
• insert the embroidery template into the
hoop
• touch «Check»
• the display changes
• the hoop position is read and the needle
positioned in the middle
• if the needle is now not positioned exactly
over the center point of the template, it has
to be adjusted with the arrows
• touch «OK»
• the adjustment will be saved, the display
closes and the selection menu appears
• touch «To Next Page»
• in theis screen the embroidery speed can be
adjusted
Motor Speed
• turning stitch width knob or touching «+»
or «–» changes the basic settings of the
speed by 6-10 stitches
• the number in the bar reflects the stitches
per minute, the basic settings are indicated
by a dark bar
031196.50.04_0507_a630_EN
Setup-Program 95