Bernina 1300MDC User Manual page 68

68 Buttonholes - Important Informaiton
Balance for Buttonholes
A
A
Balance for Direct Entry Length Standard
Buttonhole
• any Balance alterations affect both beads
Balance for Direct Entry Length Keyhole
or Round Buttonholes
• any Balance alterations affect both beads
• the keyhole or eye is balanced as follows:
• 1. sew straight stitches until the sewing
computer changes to the keyhole or eye,
then stop the sewing computer
• 2. touch «Balance» and now adjust the
picture in the right portion of the Balance
B
screen with the stitch length knob to suit
the sewn buttonhole
Balance for Manual Round or Keyhole
Buttonhole
• any Balance alterations affect both beads
differently:
if left bead is too dense (picture A)
B
• turn stitch length knob counter clockwise -
left bead will be longer, right bead will be
shorter
if left bead not dense enough (picture B)
• turn stitch length knob clockwise - left
bead will be shorter, right bead will be
longer
• the keyhole or eye is balanced as follows:
Recommendation
• sew a test on the fabric(s) you will use
Clear Balance
• touch «Reset» in the special Balance screen
or press the «clr» button («clr» deletes the
programmed buttonhole as well!)
031196.50.04_0507_a630_EN
With Direct Entry Length and
Manual buttonholes each
individual buttonhole sequence
can be balanced separately
if keyhole is distorted to the right (picture A):
• turn stitch length knob counter clockwise
if keyhole is distorted to the left (picture B):
• turn stitch length knob clockwise
• 3. touch «OK» and complete buttonhole
if keyhole is distorted to the left (picture B)
• turn stitch length knob counter clockwise
if keyhole is distorted to the right (picture A)
• turn stitch length knob clockwise
Balance for Manual Standard Buttonhole
• any Balance alterations affect both beads