Viewing Ipsec Information For An Fcip Tunnel - Brocade Communications Systems 8 Administrator's Manual

3
IPSec implementation over FCIP

Viewing IPsec information for an FCIP tunnel

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the portShow fcipTunnel command.
50
where type is the policy type and number is the number assigned.
For example, to delete the IPsec policy number 10:
switch:admin> policy --delete ipsec 10
The policy has been successfully deleted.
The following example shows the portShow fcipTunnel command used to display IPsec
information for tunnel 3:
switch:admin> portshow fciptunnel 8/ge0 3 -ipsec
Port: ge0
-------------------------------------------
Tunnel ID 3
Remote IP Addr 192.175.5.200
Local IP Addr 192.175.5.100
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:37:00:20
Compression off
Fastwrite on
Tape Pipelining on
Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 80
Max Retransmissions 9
Status : Active
Connected Count: 1
Uptime 1 hour, 16 minutes, 4 seconds
IKE Policy 7
-----------------------------------------
Authentication Algorithm: MD5
Encryption: 3DES
Perfect Forward Secrecy: off
Diffie-Hellman Group: 1
SA Life (seconds): 200000
IPSec Policy 7
-----------------------------------------
Authentication Algorithm: AES-XCBC
Encryption: 3DES
SA Life (seconds): 1500000
Pre-Shared Key 1234567890123456
Fabric OS FCIP Administrator's Guide
53-1001766-01