Brocade Communications Systems 8 Administrator's Manual page 78

3
Verifying the FCIP tunnel configuration
64
tunnel_id Displays the specified FCIP tunnel.
The following example shows an active tunnel FCIP Fastwrite and OSTP (tape pipelining)
enabled. If TCP Byte Streaming were enabled, then FCIP Fastwrite and OSTP would be
disabled.
SP3:admin> portshow fciptunnel ge1 1
Port: ge1
-------------------------------------------
Tunnel ID 1
Tunnel Description Not Configured
Remote IP Addr 192.168.15.2
Local IP Addr 192.168.15.1
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:41:2f:2e
Compression on
Fastwrite on
Tape Pipelining on
Committed Rate 200000 Kbps (0.200000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 10
Max Retransmissions 8
VC QoS Mapping off
DSCP Marking (Control): 0, DSCP Marking (Data): 0
VLAN Tagging Not Configured
TCP Byte Streaming off
Status : Inactive
Connected Count: 1
If IPsec has been enabled and a policy added to the configuration, you will see the policy
information under the status section of the output, as shown below. The policy information is
visible only when IPsec is configured, and can be displayed by entering the portShow
fciptunnel <ge_port> all command.
switch0:admin> portshow fciptunnel ge0 all
Port: ge0
-------------------------------------------
Tunnel ID 0
Tunnel Description Not Configured
Remote IP Addr 10.10.12.100
Local IP Addr 10.62.0.100
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:38:58:61
Compression on
Fastwrite on
Tape Pipelining on
Committed Rate 1000000 Kbps (1.000000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 90
Max Retransmissions 9
VC QoS Mapping on
DSCP Marking (Control): 45, DSCP Marking (Data): 30
VLAN Tagging Not Configured
TCP Byte Streaming off
Status : Inactive
Connected Count: 0
Fabric OS FCIP Administrator's Guide
53-1001766-01