Mounting The Camera - JVC VN-T216VPRU Quick Manual

Mounting the Camera

Ÿ
Place the guide pattern sticker (supplied) on the mounting surface and
mark three holes according to the guide pattern sticker. Then fasten the
sticker to the mounting surface with screws.
Ÿ
Connect the Safety Wire (Fall Prevention Wire, not supplied) to the camera
and the ceiling.
Ÿ
Secure the camera bottom case (1) to the wall/ceiling with tapping screws,
supplied.
Ÿ
Adjust the view angle (zoom, focus, and Horizontal Rotation).
To prevent the camera from falling off, ensure that it is connected to a firm place
(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not
supplied).
Pay also careful attention to the length, strength, wiring, and material (insulating
Warning
properties) of the fall prevention wire to be used. The length should be as short
as possible within the permissible range of the mounting length. The wire
should be strong enough to withstand the total weight of this product. (Pay also
attention to the finishing at the end of the wire.)
Must be isolated camera and the wall/ceiling which are connected by the Safety
Caution
Wire (Fall Prevention Wire).
Safety Wire
(Fall Prevention Wire, not supplied)
6