3-4 Restoring A Work Pc Ip Address; Enabling The Ip Address Setting - JVC VN-C3U - V-networks Pan/tilt/zoom Camera Instruction Manual

Caution
The V.NETWORKS setup tool can only be run on PCs which Setup.exe
was executed on page 17. The V.NETWORKS setup tool does not function
properly with PCs which Setup.exe has not been executed. With PCs which
Setup.exe has been executed, operation is possible from not only the CD-
ROM but also the hard disk, etc. where the setup folder is copied.
The V.NETWORKS setup tool is software that is necessary only for the
setup operation; therefore, this software should be deleted at the end of
the operation, except for PCs which may require this software for special
reasons.
When setting two or more units, reboot the PC and then return to item 2
"Connecting to a network" (page 14). When all VN-C3U setting have been
completed, proceed to the following item.

3-4 Restoring a work PC IP address

Using the same procedure as in 3-1, select Settings from the Start but-
ton, then select Control Panel and Network, Change to the original TCP/
IP properties setting that you made a note and then restore a work PC IP
address.
After restoration is completed, follow the messages of OS and reboot the
PC.

4. Enabling the IP address setting

Turn the VN-C3U power off and then on again. (When the power is turned
on, the pan/tilt reset operation will be performed; therefore, it is possible
to confirm that the power was turned on correctly by observing the pan/tilt
reset operation.)
IP addresses changed with the setup tool become effective when the
VN-C3U power is turned off and then on again. (The previous IP ad-
dress will remain effective until the power is turned off.)
Search function
The Search button is used to find the V.NETWORKS IP addresses currently
connected to the network.
When Search button is pressed, the Search screen will be displayed. When
Start Search button is pressed, a list of the V.NETWORKS IP addresses
currently connected to the network will be displayed. Timeout is used to set
the search time and can be set to 0 - 30 sec.
Caution
When your own PC and a V.NETWORKS of a different
subnet are connected on a LAN, connection will not be possible even
if the search is successful.
In such cases, change to an appropriate IP address on your PC and
then try connection.
22 00.4.7, 5:34 PM