JVC VN-C3U - V-networks Pan/tilt/zoom Camera Instruction Manual page 37

Relay alarm setting
The Relay Alarm Setting determines the actions to be performed when an
alarm signal is received from Alarm 1 and Alarm 2 input of VN-C3U. There
are two functions; Play a wave file and execute a program file. (Refer to
page 39) Make sure to select "ON" in Relay Alarm Setting of V.NETWORKS
setup tool (refer to page 21) to enable these Relay Alarm setting in this
page.
Caution
• When a large wave file (*.wav) is selected, the alarm operation may be
delayed depending on the PC specifications. Try to select a relatively
small wave file.
• In order to enable the Alarm 1, Alarm 2 and/or Relay Alarm setting it is
necessary to
1) Select "ON" in Alarm 1, Alarm 2 and/or Relay Alarm setting of
V.NETWORKS setup tool (refer to page 21),
and
2) Check ( ) Alarm reg.
• When relay alarm has been set, the second alarm operations is not
performed.
Example: When the Relay Alarm occurs in the sequence of
Alarm 1 Alarm 2, alarms operate in the sequence of
Alarm 1 Relay Alarm and Alarm 2 does not operate at all.
To enable the Alarm 1, Alarm 2 and/or
Relay Alarm settings, it is necessary
to check ( ) Alarm reg.
38 00.4.7, 5:35 PM