Alarm Output - Samsung SCP-3120 User Manual

Alarm Output

►
Main Menu/Alarm Setting/Alarm Output
•
Setting 1,2 :
1, 2, Motion, and Support Device indicate
alarm input ports, Motion Detection, and
support device input. A total of 4 alarms,
Motion Detection, and support devices can be
set up to output alarms. 1 alarm output port
can be used for more than 2 alarm inputs and
Motion Detection.
•
Timer 1,2 :
Enables selecting an Alarm Output method.
-
On : Retains an alarm output for a set
duration from a minimum of 1 second
to a maximum of 60 minutes upon the
alarm occurrence.
-
Momentary : Retains an alarm output only
❋
The Alarm Output is equipped with a relay
circuit. The operation of the alarm output port
is as shown in the diagram below.
NO
COM
NC
Alarm Out OFF

M
Connecting the power connector and GND incorrectly to the NC/NO and COM ports
may cause a short circuit and fi re, damaging the camera.

The maximum power capacity of the built-in relay is 30VDC/2A, 125VAC/0.5A, and
250VAC/0.25A. Operating the camera beyond the capacity may decrease the
camera's lifespan and damage it.
until the alarm is canceled.
Alarm Out ON
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Password Setting
Status
Alarm Setting
Alarm Enable
Alarm Input
Alarm Output
MD Dwell Time
Alarm Output
Setting 1
NO
Setting 2
COM
Timer 1
Timer 2
NC
OUT Off 1
OUT Off 2
English
OFF
OFF
1 2 MD AUX
1 2 MD AUX
OFF
OFF
English _ 83