ROSE DISPLAYS SPIDER CEILING TRACK WITH SCREWS Manual

Spider™ Ceiling Track

Parts

Instructions for Hanging

Step 1

Place Spider Ceiling Track in position and mark
all mounting holes on ceiling. Fig. 1
Note: Determine what type of ceiling you have
and choose the appropriate mounting anchor for
your ceiling type.
For plaster board ceilings use toggle bolt anchors.
For hard wood ceilings use wood screw anchor.
Plastic expansion anchors are not recommended
for installation of this system.

Step 2

Drill pilot holes for appropriate anchor. Fig. 2
Note: Use a 3/8" masonry bit for plasterboard/
drywall when installing with toggle bolts.
Use a #48 or .076" drill bit when installing
Spider ceiling track using wood screws.

Step 3

Place bolts or screws through mounting holes in
Spider ceiling track. Fig. 3 If using toggle bolts,
attach wing nuts to bolts and insert into predrilled
holes in ceiling. Tighten bolts or screws until Spider
ceiling track is snug and secure to ceiling.

Step 4

Install Signware OneUp anchors with ladderless
RoPole installation tool.
TM
The Spider Ceiling Track trademark of Rose Displays, Ltd. Neither the manufacturer
nor any sales agent may be held liable for injury, loss or damage resulting from the use of
these products. Part #00INSSpider Ceiling Track
Incept-9.5.00
Spider™
Ceiling Track
25-0027
Toggle Bolts Wood Screws
Instruction Sheet
Figure 1
Figure 2
Figure 3
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com