ROSE DISPLAYS ANOFRAME SQUARE WITH CABLE CLIP AND LOOP AND SAUCER Manual

AnoFrame

Parts

Loop and
Saucer
16-0018SL

Instructions for assembly

Step 1

Insert corner brackets into vertical
AnoFrame sides. Fig. 1 & Fig. 2. Note:
Assembly brackets tension tabs face
towards outside of frames. Split rail side
is made up of 2 separate pieces.

Step 2

Place cable onto inner channel of Cable
Clip. The cable should snap into place.
Fig. 3

Step 3

Align one end of the Cable Clip with the
top channel of the aluminum holder.
Then insert one round end, then press
down on the other round end and slide
Cable Clip into rail. Fig. 4

Step 4

Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.

Step 5

Insert poster. Fig 6.
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipLoopSaucer
Incept-9.27.02
TM
-Square Profile
Corner
brackets
AnoFrame rails AnoFrame
12AF100SQ split rails
Figure 1
Figure 3
solid rail w/
4
3
solid rail
Figure 5
Instruction Sheet
Cable Clips
06-5050
1
Figure 2
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
2