ROSE DISPLAYS ANOFRAME SQUARE WITH CABLE CLIP AND BALL CHAIN Manual

AnoFrame

Parts

Ball Chains
96-0302P

Instructions for assembly

Step 1

Insert corner brackets into vertical AnoFrame
sides. Fig. 1 & Fig. 2. Note: Assembly
brackets tension tabs face towards outside of
frames. Split rail side is made up of 2 separate
pieces.

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 3

Step 3

Align one round end of cable clip with top
channel of the aluminum rail and insert. Once
in place, insert end of ball chain into channel.
Then press down on the other round end of the
cable clip and slide into rail by pushing on the
clip. Fig. 4 Repeat steps 2 & 3 for second cable
clip.
Note: Be sure to push on the cable clip in
order to slide the ball chain into place. Do
not pull on, or push against, the ball chain as
this will cause it to bind in the channel.

Step 4

Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.

Step 5

Insert poster. Fig 6.
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipBallChain
Incept-9.24.02
TM
Instruction Sheet
Corner AnoFrame rails
brackets
AnoFrame
12AF100 split rails
Figure 1
Figure 3
solid rail w/
4
3
solid rail
Figure 5
Cable Clips
06-5050
1
2
Figure 2
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com