Classe Audio CAP-2100 - MANUEL 2 Owner's Manual page 18

Important!
Danger!
18
11 Ground terminal
The ground terminal on your integrated amplifier is most often used for
the ground wire of a turntable, assuming you have the optional phono
module installed (see your authorized Classé dealer for more information
on this option if you are interested).
Connecting the ground wire from your turntable's tonearm to this screw
terminal usually minimizes any hum or buzzing to which the turntable
might otherwise be susceptible. Your authorized Classé dealer can assist
you in handling this problem if it should arise.
12 AC Mains Fuse
An AC mains fuse holder is located next to the AC mains input. It is
unlikely that you should ever have to replace this fuse, but if you do, it is
critical that you do so only with a fuse of exactly the same rating and value
(specified in Troubleshooting #8).
Never replace a blown fuse on this or any other piece of
electronics with anything other than a fuse of exactly the
same rating and value. Doing so can cause damage to your
electronics that may not be covered by the warranty.
Always disconnect the integrated amplifier from the AC
mains and from the speakers before attempting to replace
a fuse. If the fuse blows again upon powering back up,
contact your authorized Classé dealer for assistance.
There are no user-serviceable parts inside the CAP-2100.
13 AC Mains Input
An IEC standard power cord (supplied) is used with the CAP-2100.
Plug the cord into the IEC receptacle provided, and the other end into a
suitable wall outlet.
14 AC Mains Power Switch
The main power switch for the CAP-2100 is located near the middle of
the rear panel, beside the receptacle for the power cord.
The integrated amplifier should be in standby before being switched off.
Switching the unit on puts it in standby mode.
Potentially dangerous voltages and current capabilities exist
within your integrated amplifier, even when disconnected
from AC mains. Do not attempt to open any portion of the
integrated amplifier's cabinet. There are no user-serviceable
parts inside your integrated amplifier. All service of this
product must be referred to a qualified authorized Classé
dealer or distributor.
.
.