Using Can-Bus - Classe Audio CA-M400 Owner's Manual

using CAN-Bus CAN-Bus is controlled via the touchscreen of any Delta series component. Th ere
20
Th e diagrams below illustrate how to connect the CAN-Bus hardware.
Any combination of models in any order without SSP-300 or SSP-600.
Any combination of models in any order with SSP-300 or SSP-600.
NOTE: Daisy chain may need to be terminated with CAN-Bus Terminator.
is no master component, so Delta series systems where two or more units have
a touchscreen can be controlled through any of the touchscreens. However, it is
probably easiest to start using CAN-Bus through just one.
CAN-Bus is accessed by pressing the menu button on the face of the unit or
remote, then the status button, followed by the more button.
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT