CM 5311A Operating, Maintenance & Parts Manual

CM 5311A Operating, Maintenance & Parts Manual

Hand operated lever hoist

Advertisement

OPERATING, MAINTENANCE
& PARTS MANUAL
MANUAL DE FUNCIONAMIENTO,
MANTENIMIENTO Y PIEZAS
MANUEL D'ENTRETIEN,
D'OPÉRATION ET DE PIÈCES
HAND OPERATED LEVER HOIST
POLIPASTO MANUAL DE PALANCA
PALAN MANUEL À LEVIER
SERIES 653-A
LEVER HOIST
Before installing hoist, fill in the information below.
Antes de instalar el polipasto, rellene los datos siguientes.
Enregistrez les informations suivantes avant de faire l'installation.
Rated Load
/ Carga Nominal / Charge nominale
Serial No.
/ N° de Serie / No. de Ser.
Purchase Date
/ Fecha de Compra / Date d'achat
CAPACITIES:
3/4, 1, 1½, 2, 3 and 6 TON
(750, 1000, 1500, 2000,
3000 and 6000 kg.)
Follow all instructions and warnings
for inspecting, maintaining and
operating this hoist.
The use of any hoist presents some risk
of personal injury or property damage. That
risk is greatly increased if proper instructions
and warnings are not followed. Before using
this hoist, each operator should become
thoroughly familiar with all warnings,
instructions and recommendations
in this manual. Retain this manual for
future reference and use.
Forward this manual to operator.
Failure to operate equipment as
directed in manual may cause injury.
CAPACIDADES DE CARGA:
3/4, 1,1½, 2, 3 y 6 toneladas
(750, 1000, 1500, 2000, 3000 y
6000 kg.)
Siga todas las instrucciones y
advertencias para inspeccionar,
mantener y operar este polipasto.
El uso de cualquier polipasto presenta algunos
riesgos de daños a las personas o a las
cosas. Este riesgo se ve incrementado si no
se siguen correctamente las instrucciones
y advertencias. Antes de usar el polipasto
el operario debería estar familiarizado con
rodas las advertencias, instrucciones y
recomendaciones de este manual. Guarde
este manual para futuras consultas.
Entregue este manual al operario. Si el
equipo no se maneja tal y como se
recomienda en el presente manual, es
posible que se produzcan situaciones
de peligro que pueden resultar en
daños personales.
CHARGES NOMINALES:
3/4, 1,1½, 2, 3 et 6 TONNES
(750, 1000, 1500, 2000, 3000 et
6000 kg.)
Veuillez vous conformer à toutes les
instructions et avertissements d'inspection,
d'entretien et d'opération de ce palan.
L'utilisation de tout appareil de levage
comporte des risques de blessures ou
de dégâts matériels. Ces risques sont
de beaucoup accrus si les instructions
et avertissements ne sont pas suivis.
Tous les opérateurs devraient se
familiariser complètement avec toutes
les recommandations instructions et
avertissements de ce manuel avant d'utiliser
ce palan. Conservez ce manuel pour
utilisation et référence future.
Remettre ce manuel à l'opérateur.
L'utilisation de cet équipement contrairement
aux directives de ce manuel peut causer
des blessures.
P/N: 192065084 Rev AA March 2020

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5311A and is the answer not in the manual?

Questions and answers

Summarization of Contents

WARRANTY
LIMITATION OF WARRANTIES, REMEDIES AND DAMAGES
Limits seller's liability and defines buyer's rights regarding defects.
INDEMNIFICATION AND SAFE OPERATION
Buyer's responsibility for safe use and protection against claims.
CMCO Warranty (HOISTS)
Specific warranty terms for CM hoists, including duration and coverage.
GENERAL SAFETY INFORMATION
ADVERSE ENVIRONMENTAL CONDITIONS
Precautions for using the hoist in specific environmental conditions.
MOVING HAZARDOUS LOADS
Warnings against lifting materials that could cause widespread damage if dropped.
UNPACKING
CM® REPAIR/REPLACEMENT POLICY
Seller's policy for repairing or replacing defective hoist units.
OPERATION
FREE CHAINING
How to engage and use the free chaining feature for quick load attachment.
LOCKED BRAKE
Explanation of the brake locking mechanism and how to unlock it.
ATTACHING THE LOAD
Correct procedures for securely attaching the load to the hoist hook.
TO PULL OR LIFT THE LOAD
Instructions on operating the lever to lift or pull loads safely.
TO LOOSEN OR LOWER LOAD
Steps for safely lowering or loosening a load with the hoist.
INSPECT HOIST
Guidelines for pre-use inspection of the hoist and rigging.
MAINTENANCE
INSPECTION
General overview of inspection procedures for safe operation.
FREQUENT INSPECTIONS
Daily visual checks by the operator for safe hoist operation.
PERIODIC INSPECTIONS
Regular detailed checks by a designated person for hoist condition.
CHAIN INSPECTION
Detailed examination of the load chain for wear, damage, or defects.
CHAIN LUBRICATION
Proper lubrication of the load chain to ensure longevity and performance.
DISASSEMBLY AND ASSEMBLY
Procedures for taking apart and putting together hoist components.
GEAR TIMING
Proper alignment of gear teeth during assembly for correct operation.
REPLACING LOAD CHAIN
Steps to remove and install a new load chain on the hoist.
SPARE PARTS
RECOMMENDED SPARE PARTS
List of recommended parts for repair and replacement.
TESTING
HOIST TESTING PROCEDURES
Protocols for testing hoist operation and brake function after repair or initial use.
TROUBLESHOOTING CHART
HOIST HARD TO OPERATE IN EITHER DIRECTION
Diagnosing and resolving operational difficulties in both directions.
HOIST HARD TO OPERATE IN DOWN DIRECTION
Identifying causes for stiff operation when lowering a load.
HOIST HARD TO OPERATE IN UP DIRECTION
Identifying causes for stiff operation when lifting a load.
REPAIR PARTS LIST
ORDERING INSTRUCTIONS
Information required when ordering replacement parts for the hoist.

Table of Contents