Dynabrade Sander Series Disassembly And Assembly Instructions

Disassembly, Assembly Instructions - 2.8 hp Grinder/Sander Series:
Ø 7" & 9", Right Angle
Models: Use for all models.
Important: Disconnect from the air supply.
Notice: Use these instructions along with the specific tool manual for each model.
To avoid damage, use the proper repair tools designed for motor disassembly and
assembly.
Ÿ Remove any flanges, abrasive, back-up disc or guard.
Motor Disassembly: (Tutorial shows tool with 54951 Spindle. - Applies to all models.)
1. Fasten housing in vise (bronze or aluminum jaws) with throttle handle pointing up.
• Use a 4mm hex key to remove 95720 Screws (4). Turn counterclockwise.