Table of Contents
Advertisement
AUSTRALIA
NSW - Sydney (HEAD OFFICE)
Tel: +61 2 9898 8686
VIC/ TAS - Melbourne
Tel: +61 3 9764 1211
WA - Perth
Tel: +61 8 9273 1900
QLD – Brisbane
Tel: +61 7 3299 9900
SA/ NT - Adelaide
Tel: +61 8 8244 6000
NEW ZEALAND
CANADA / NORTH-EAST USA
Waterco (NZ) Limited
Waterco Canada Inc
Auckland, New Zealand
Quebec, Canada
Tel: +64 9 525 7570
Tel: 1 888 796 6002
USA
EUROPE
Waterco USA Inc
Waterco (Europe) Limited
Augusta, USA
Tel: +17067937291
Sittingbourne, Kent. UK
Tel: +44(0) 1795 521 733
+18002477291
Website / Internet :
www.waterco.com
This web site address will enable you to select the appropriate country website.
Ce site web vous permettra de choisir le pays avec lequel vous devrez communiquer.
Waterco Limited ABN 62 002 070 733
(ZZM1331) 04/2012
CHINA
Waterco (C) Limited
Guangzhou, China
Tel: +8620 3222 2180
MALAYSIA
Waterco (Far East) Sdn. Bhd.
Selangor, Malaysia
Tel: +60 3 6145 6000
WATERCO POOL HEAT PUMP
WATERCO THERMOPOMPE CHAUFFE-PISCINE
User and
Care Guide Manual
Guide d'utilisation
et d'entretien
This equipment must be installed and serviced by a qualified technician. Improper
installation can create electrical hazards which could result in property damage,
serious injury or death. Improper installation will void the warranty.
Cet équipement doit être installé et réparé par un technicien qualifié. Une mauvaise
installation peut entraîner des risques électriques qui pourraient provoquer des
dommages, des blessures graves ou la mort. Une installation inadéquate annulera
la garantie.
Notice to Installer / Avis à l'installateur
This manual contains important information about the installation, operation and safe
use of this product. Once the product has been installed, this manual must be given
to the owner/operator of this equipment.
Ce manuel contient des informations importantes sur l'installation, l'exploitation et
l'utilisation sécuritaire de ce produit. Une fois que le produit a été installé, ce manuel
doit être remis à l'acheteur et/ou utilisateur de cet équipement.
www.waterco.com
Advertisement
Table of Contents
Related Manuals for Waterco XLR
Summarization of Contents
General Safety Instructions
Usage of Chemical Products
Guidelines for maintaining proper pool water chemistry to protect the heat pump.
Installation Instructions
Location
Guidance on selecting the optimal placement for the pool heat pump unit.
Water Piping and Plumbing
Recommended piping sequence, diagram, and connection methods for the unit.
Electrical Requirements
Critical electrical connection, breaker size, wire size, and safety requirements.
Bonding Procedures
Guidance on grounding and bonding metal components of the pool system.
Pool Heat Pump Operation
Initial Heating and Running Time
Procedures for initial heating and recommendations for optimal operating hours.
Solar Blankets and Defrost Cycle
Benefits of solar blankets and explanation of the automatic defrost mode.
Electronic Control Overview
Functions of the control panel, starting, stopping, and temperature settings.
Temperature Calibration
Procedure to calibrate the displayed temperature to match a pool thermometer.
Timer and Remote Control Integration
Information on using timers with the pool pump and installing remote controls.
Protection Devices and Bypass Valves
Explanation of safety controls and correct bypass valve settings for optimal flow.
Maintenance of Your Pool Heat Pump
Cabinet and Evaporator Cleaning
Instructions for cleaning the unit's exterior and internal evaporator coil.
Winterizing Procedures
Essential steps to properly drain and protect the unit from freezing temperatures.
Troubleshooting - Initial Checks
Nothing Is Working
Initial checks for common issues when the unit does not power on or function.
Troubleshooting - Control and Component Issues
Control Display Errors
Diagnosing issues when the control panel shows error codes or digits.
Fan and Compressor Malfunctions
Troubleshooting problems related to the fan motor and compressor operation.
Water Flow and Noise Issues
Addressing water around the unit and identifying causes of unusual noise.
Troubleshooting - Performance Issues
Ice Formation on Evaporator
Steps to address and prevent ice formation on the evaporator coil.
Unit Not Heating Properly
Common causes and solutions when the unit fails to heat the pool water.
Troubleshooting - System Checks
Analysis Chart for Performance
A chart to record operational data for diagnosing heating performance issues.
Circuit Breaker Tripping
Troubleshooting steps when the circuit breaker repeatedly trips.
Temperature Display Discrepancies
Resolving differences between the unit display and a pool thermometer.
Service Analyser Codes - Part 1
Probe and Flow Related Codes
Troubleshooting codes for temperature probes and water flow issues.
Defrost and Control Related Codes
Understanding codes for defrost cycles and electronic control faults.
Service Analyser Codes - Part 2
Refrigerant and Circulation Codes
Diagnosing problems related to refrigerant levels and water circulation.
High Temperature and System Errors
Addressing codes for high water temperature and general system errors.
Product Warranty Information
Warranty Exclusions
List of conditions and actions not covered under the product warranty.
Need help?
Do you have a question about the XLR and is the answer not in the manual?
Questions and answers