Rear Panel; Hardware Connections; Connect The Router Using Lan - Encore ENHWI-G2 User Manual

Rear Panel

The figure below shows the rear panel of the Wireless Broadband Router.
Antenna
Connect the supplied detachable 2 dBi Gain Antenna in the rear panel for wireless connection.
LAN (1-4)
Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either 10Mbps or 100Mbps
Ethernet connections (auto detection).
WAN
One RJ-45 10/100 Mbps auto-MDIX port for Internet WAN connection. This is where the
xDSL or Cable modem should be connected.
DC IN
Power adapter port. Plug-in the supplied power adapter to this port.
RESET
Use a pin or a similar object to push this button to reset the unit settings to the factory default
settings.

Hardware connections

Connect the ENHWI-G2 802.11g Wireless Broadband Router to LAN
1. Plug-in one end of UTP RJ-45 network cable to the WAN port of the ENHWI-G2 802.11g
Wireless Broadband Router, while the other end connects to the Ethernet port of the xDSL
or Cable modem.
2. Use UTP RJ-45 network cable to connect four computers to the router. Connect one end of
the UTP Rj-45 cable to the computer's Ethernet card or laptop PC and the other end
connects to any of the four LAN ports of the ENHWI-G2 802.11g Wireless Broadband
Router. You can connect up to four wired computers.
Figure 1. Rear Panel
6