Table of Contents
Advertisement
HARDWARE INSTALLATION
Front Panel
The figure below shows the front panel of the ENHWI-G2 802.11g Wireless Broadband Router.
Power LED
Lights in Red when power is on.
Status
When this indicator blinks green it means the Wireless Broadband Router is working successful.
Otherwise, hen this indicator blinks on-and-off it means the Internet Broadband Router is
failing to establish internet connections.
WAN (Link/ACT)
When Green indicates a WAN port is being use and connected to the xDSL or Cable Modem
devices. When this indicator blinks green, the WAN port is transmitting-receiving data from the
xDSL or Cable modem whichever your ISP is.
WLAN (ACT)
This indicator LED lights up in Green when a wireless device is connected and transmitting
data to and from the ENHWI-G2 802.11g Wireless Broadband Router.
to
LAN (Link/ACT)
LAN wired ports 1 to 4. When in solid light Green it indicates a good connection. When
flashing green it indicates the appropriate port is receiving / transmitting data.
– Button use to configure and connected using the "Wireless Protected Setup" feature
WPS
5
Advertisement
Table of Contents
