Related Manuals for Side-Power SE120/215T IP
Summarization of Contents
Stern Thruster Installation Considerations
Additional Considerations for Positioning
Guidance on positioning the stern thruster, ensuring it doesn't interfere with hull flow or other boat equipment.
Electrical Installation
Electrical Table Explanation
Explanation of the table detailing cable lengths, battery size, and fuse recommendations for thruster installation.
Cable Size and Battery Capacity
Ensuring adequate cable size and high-capacity batteries for optimal thruster performance and voltage.
Main Switch and Fuse Installation
Guidance on installing a main switch and fuse for safety and protection against short-circuits.
Control Panel and Control Leads
4-Pole AMP Contact Pin Configuration
Details the function of each pin (BLACK, BLUE, GREY, RED) in the 4-pole AMP control connector.
Electrical Installation of Stern Thruster Systems
Dual Joystick Panel Wiring
Diagrams and notes on connecting dual joystick panels for bow and stern thruster systems.
Checklist
IP Protection Checklist
Specific checklist items ensuring the thruster's Ignition Protection (IP) rating is maintained during installation.
Pre-Delivery Tests by Installer
Additional tests for installers to perform before delivery if standard quality control systems are not used.
How to Use Sidepower Thrusters
How to Use a Bowthruster
Step-by-step instructions on operating a bowthruster, including power on, control engagement, and maneuvering.
How to Use a Single Stern Thruster
Guidance on operating a single stern thruster, similar to a bowthruster operation.
How to Use Bow and Stern Thrusters Combined
Explains the combined operation of bow and stern thrusters for enhanced maneuverability and sideways movement.
Troubleshooting
Electromotor Runs, No Thrust
Diagnosing and resolving issues where the motor operates but no thrust is generated, checking coupling and propellers.
Thruster Fails to Start or Works in One Direction
Troubleshooting steps for a thruster that won't start or only operates in a single direction, checking voltage and wiring.
Low Performance Issues
Addressing reduced thruster performance by checking voltage, brush springs, and tunnel/propeller cleanliness.
Intermittent Operation (0.5s/4s)
Resolving intermittent operation likely caused by low voltage or solenoid flapping issues.
Intermittent Operation (0.5s/10s) / Solenoid Lock-in
Troubleshooting solenoid lock-in and auto-retry issues causing brief, repeated thruster operation.
Need help?
Do you have a question about the SE120/215T IP and is the answer not in the manual?
Questions and answers