Maytag MER5750BAQ - Electric Range Installation Manual page 6

CONNECTING THE RANGE
FIGURE 6
3-Wire Service Cord or Conduit Installation
1. Insure that the copper ground strap IS CONNECTED
between the middle post of the main terminal
connection block and the range chassis.
2. The middle wire of the service cord or ground lead of
3-wire conduit MUST connect to the neutral (middle)
post of the main terminal block. The other two wires of
the service cord or conduit connect to the outside
posts of the main terminal connection block. Polarity is
unimportant.
3. An appropriate strain relief for service cord or conduit
MUST be attached to the conduit plate.
ACCEPTABLE - 3 WIRE PLUG INSTALLATION
WH
BLACK-_\
\
GROUND STRAF
(CONNECTED AT
FACTORY)
STRAIN
RELIEF
MAIN TERMINAL
CONNECTION BLOCK
IDDLE WIRE OF
SERVICE CORD OR
GROUND LEAD OF
CONDUIT. _
_,_"1 /--STAMPED
CONDUIT _%_'Sj_,,'_"IL/" CONDUIT
PLATE __
i/ v _ FOR USE WITH CONDUIT,
STAMPED _/ REMOVE BRACKET, FLIP
CORD & RE-ATTACH WITH HOLE
MARKED "CONDUIT"
DOWN.
Z OUT_
MOUNTED FLUSH TO WALL
ALTERNATE INSTALLATION
OUTLET RECEPTACLE TO BE
ROTATED AS SHOWN IF NOT
FLUSH TO WALL
FIGURE 6
-6-