Optional Positioning Of Thermostat Sensing Bulb - Comfort Glow CCL3018P Owner's Operation And Installation Manual

Unvented (vent-free) propane/lp gas log heater

Hide thumbs Also See for CCL3018P:

Owner's operation and installation manual (44 pages)

Table Of Contents

Table of Contents

OPTIONAL POSITIONING OF

THERMOSTAT SENSING BULB

For Masonry and Factory-built

Metal Fireplace

If your log set cycles to pilot, but the room temperature drops to a

lower than ideal comfort level before the log set comes back on, you

may want to reposition the thermostat sensing bulb.

The thermostat sensing bulb is located near the gas valve assembly

on the mounting bracket. This location allows the thermostat to keep

the room temperature at an ideal comfort level for most fireplace

applications. For positioning the thermostat sensing bulb else-

where, an adhesive-backed mounting clip is available.

Tools needed: 1/4" hex driver or socket

Remove logs. Locate the gas valve assembly and thermostat

sensing bulb (see Figure 47).

With 1/4" hex driver or socket, loosen the thermostat screw.

Carefully slide the thermostat sensing bulb out of the retaining

clamp (see Figure 49).

Note: Do not remove the screw. Make sure you tighten the

screw after removing the thermostat sensing bulb.

IMPORTANT: Do not force or bend the thermostat sensing

bulb or capillary.

The thermostat sensing bulb may be located to the lower right

front side of fireplace. Determine location of sensing bulb, but

do not mount sensing bulb until step 5. If you have a masonry

fireplace, see Figure 50 for location. If you have a factory-built

metal fireplace, see Figure 51 for location. If your fireplace

has glass doors, position sensing bulb directly behind door gap

on right bottom side (see Figure 52).

The mounting clip must be a minimum of 3" from bottom of

fireplace to prevent crimping of capillary. Once you have de-

cided on a location, clean the area thoroughly. Remove the pa-

per backing from the adhesive on back of mounting clip. Press

the clip into the new location so that the thermostat sensing bulb

will be positioned vertically with the capillary at the bottom

(see Figure 53). Slide the thermostat sensing bulb into the clip.

IMPORTANT: Do not crimp capillary.

Gas Valve

Assembly

Mounting

Bracket

Figure 47 - Location of Gas Valve Assembly and Thermostat

Sensing Bulb

For more information, visit www.desatech.com

107124-01E