Comfort Glow CCL3018P Owner's Operation And Installation Manual page 14

INSTALLATION
14
Installing Logs (Cont.)
INSTALLATION
Continued
2. Place the base of the middle log (#2) in the U-shaped slots of the
grate base in front of the back log. The cutout on the right of the
middle log should fit over the burner (see Figure 20). Make sure
the front of the middle log is resting on the tabs of the grate base
and the cutout area is centered over the burner "U" bend.
3. Locate the recesses on the back of the front log (#3). Fit these
recesses between the posts of the grate base (see Figure 21).
4. Locate the notches in the bottom of the crossover log (#4). Place
the crossover log on top of the middle log and front log. Make
sure the notches of the crossover log lines up with rectangular
knobs on top of the middle and front logs (see Figure 22).
5. Place lava rock around base of heater if desired. Do not put
lava rock on logs on burner.
Tab
Burner
Figure 20 - Installing Middle Log (#2)
Front Log (#3)
Post
Figure 21 - Installing Front Log (#3)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Middle Log (#2)
Cutout
"U" Bend
U-Shaped Slot
Recess
Post
Notches
Rectangular
Knobs
Figure 22 - Installing Crossover Log (#4)
Dual Burner Premium Aged Split Oak Models
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
Each log is marked with a number. These numbers will help you identify
the log when installing. It is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs supplied with heater.
1. Place the base of the middle log (#1) in the U-shaped slots of
the grate base. The cutout on the right of the middle log should
fit over the burner (see Figure 23). Make sure the front of the
middle log is resting on the tabs of the grate base and the cut-
out area is centered over the burner "U" bend.
Tab
Burner
Figure 23 - Installing Middle Log (#1)
Crossover Log (#4)
Middle Log (#1)
"U" Bend
U-Shaped Slot
107124-01E