Comfort Glow CCL3018P Owner's Operation And Installation Manual page 15

INSTALLATION
Continued
2. Locate pins on the bottom of back log (#2). Slide these pins into
the holes in the grate base behind the burner (see Figure 24).
3. Place crossover log (#3) onto the pin (right) on middle log (#1) and
into the recess of the back log (#2). See Figure 25.
4. Locate the notches in the bottom of the front log (#4). Place
the front log on the grate fingers. Make sure the notches of the
front log line up with the grate fingers. See Figure 26.
Pin
Hole in
Grate Base
Burner
Figure 24 - Installing Back Log (#2)
Figure 25 - Installing Crossover Log (#3)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107124-01E
Back Log (#2)
Crossover Log (#3)
Recess
Pin
5. With knot to right side, place smaller log piece (#5) over the
pin on the left side of the middle log. The smaller log will rest
on front log against the "knot" on the left. See Figure 27.
6. Place lava rock around base of heater if desired. Do not put
lava rock on logs on burner.
Grate Fingers
Figure 26 - Installing Front Log (#4)
Pin
Figure 27 - Installing Log Piece (#5)
INSTALLATION
Installing Logs (Cont.)
Front Log (#4)
Notches
Log Piece (#5)
15
15