Sony BVM-E250 Operation Manual page 46

Menu
Original Value
Signal
Contrast/Bright Hold
Copy From
Preset Value
Other Monitor
Monitor ID
46
Adjustment Menu
Function and operation ([
Sets the initial value.
Except for the XYZ format signal
You can select from D93, D65, D61, D55, D-Cine, User1, User2, User3, User4 or User5.
When D93, D65, D61, D55 or D-Cine data is changed, they are displayed as D93*, D65*,
D61*, D55* or D-Cine*.
For the XYZ format signal
You can select from D-Cine XYZ, User XYZ1, User XYZ2, User XYZ3, User XYZ4 or User
XYZ5.
When D-Cine XYZ data is changed, it is displayed as D-Cine XYZ*.
Sets the white signal to be used for adjustment.
[Internal]: Select when an internal signal is used. The signal is automatically switched
in synchronization with the gain and bias adjustments.
External: Select when an external input signal is used. Supply a signal to be used when
adjusting gain and bias.
Note
If Internal is selected for the XYZ format signal, the Calibration White signal is displayed.
Sets the contrast and brightness to the adjusted value or the center value.
Off: Sets contrast and brightness to the center values during and after color temperature
adjustment.
[On]: Retains the adjusted contrast and brightness values during and after color
temperature adjustment.
Copies the other color temperature.
Note
Use the controller with software version 1.6 or higher to use the Copy From function.
Copies other data in this monitor.
Except for the XYZ format signal
When the item is selected, you can select from D93, D65, D61, D55, D-Cine, User1, User2,
User3, User4 or User5.
D93: Copies the color temperature of D93.
D65: Copies the color temperature of D65.
D61: Copies the color temperature of D61.
D55: Copies the color temperature of D56.
D-Cine: Copies the color temperature of D-Cine.
User1 to 5: Copies the color temperature of User1 to 5.
When D93, D65, D61, D55 or D-Cine data is changed, they are displayed as D93*, D65*,
D61*, D55* or D-Cine*.
For the XYZ format signal
When the item is selected, you can select from D-Cine XYZ, User XYZ1, User XYZ2, User
XYZ3, User XYZ4 or User XYZ5.
D-Cine XYZ: Copies the color temperature of D-Cine XYZ.
User XYZ1 to 5: Copies the color temperature of User XYZ1 to 5.
When D-Cine XYZ data is changed, it is displayed as D-Cine XYZ*.
Copies data from another monitor.
Enter the ID number of the source monitor.
When the NETWORK switch is set to PEER TO PEER, this is not selectable.
Except for the XYZ format signal
When the ID number is entered, you can select from D93, D65, D61, D55, D-Cine, User1,
User2, User3, User4 or User5.
D93: Copies the color temperature of D93.
D65: Copies the color temperature of D65.
D61: Copies the color temperature of D61.
D55: Copies the color temperature of D55.
D-Cine: Copies the color temperature of D-Cine.
User1 to 5: Copies the color temperature of User1 to 5.
When D93, D65, D61, D55 or D-Cine data is changed, they are displayed as D93*, D65*,
D61*, D55* or D-Cine*.
]: factory setting)