Operation - Chicago Electric Power Systems 97047 Set Up And Operating Instructions Manual

positive
1. Place the Power Inverter on a flat surface that has adequate ventilation and is
not in direct sunlight. Fasten the inverter securely to the surface, using screws
or some other means. If holes are to be drilled, follow safe, proper installation
techniques. Verify that installation surface has no hidden utility lines before
drilling or driving screws.
2. Connect the Battery Cable (not included; #2 AWG or larger cables) lugs to the
(Positive) red and (Negative) black terminals on the back of the Inverter, see
above. Connect the Ground Cable (not included; #4 AWG or larger cable) lug to
the Ground terminal, see picture above. Securely tighten.
3. The Power Inverter can be used either while the engine is running or off.
Connect the Battery Cables (not included) to the Negative (black) and Positive
(red) terminals of the battery.
4. Connect the Ground Cable to the appropriate location below:
• If this unit is mounted within a vehicle with a grounded metal chassis, attach
the Ground Cable to a nearby location on the chassis.
• If this unit is mounted in a boat or vehicle with an ungrounded chassis, attach
the Ground Cable to the vehicle's grounding system.
• Only if this unit is being used outside a vehicle, attach the Ground Cable to
the Negative Terminal of the Inverter.
wArning wArning
1. Plug the 11 VAC device(s) you wish to power into the 3-prong AC Receptacles.
See illustration on the next page. The appliance(s) must not use more than
1,000 (total) watts during continuous operation, otherwise it may overload the
Inverter.
SKU 97047
negative
never operate this inverter unless it is properly grounded.
For technical questions, please call 1-800-444-3353.

operAtion

ground
Page 9