Operation; Maintenance - Chicago Electric 92464 Assembly And Operating Instructions Manual

Warning: NEVER operate this inverter unless it is properly grounded.
1. Open the rubber cover on the receptacle(s) and plug the 115 VAC device(s)
you wish to power into the 3-prong AC Receptacles. See FRONT above. The
appliance(s) must not use more than 2,000 (total) watts during continuous
operation, otherwise it may overload the Inverter.
Caution: Some rechargeable appliances may damage the Power Inverter or
the appliance. When first using a rechargeable device, check the inverter's
temperature for the first 10 minutes. If it becomes abnormally hot, do not use
this device with the Inverter.
2. Flip the Power Switch to the On (I) position to turn on. Do not use the appliance
until the green power LED indicator is on.
3. Turn on appliance. If an alarm sound is heard, turn off the appliance.
Caution: It is recommended that the vehicle be started every hour to recharge
the battery system. Doing this will help prevent any unexpected shutdown
of the equipment. This will also help ensure that there will be enough battery
power to start the vehicle. Due to the risk of carbon monoxide inhalation (see
Warning # 22 on page 4), do not run the vehicle's engine within an enclosed
area.
4. After use, disconnect the appliances, flip the Power Switch to the Off (O) position,
and put the rubber covers back in place over the receptacles.
1. Keep this unit clean and dry. Unplug the unit before cleaning. Clean only the
outside of this unit with a soft, dry cloth; never clean this unit with water or harsh
cleaners.
2. This device does not contain any user replaceable parts. If it needs service,
take it to a qualified technician.
Due to the sensitive wiring and electrical circuits within this device, and the
possibility of injury, the fuses inside this unit are to be replaced only by a qualified
technician.
Fuses are included only for replacement by a technician.
For technical questions, please call 1-800-444-3353.
SKU 92464
FRONT
Outlets
(covered)

Operation

Maintenance

Power
Indicator
Switch
Page 6