Operation; Maintenance - Chicago Electric Power Systems 93761 Assembly And Operating Instructions Manual

Power LED
Switch
Warning: NEVER operate this inverter unless it is properly grounded.
1. Plug the 115 VAC device(s) you wish to power into the 3-prong AC Receptacles.
See FRONT above. The appliance(s) must not use more than 1,200 (total) watts
during continuous operation, otherwise it may overload the Inverter.
Caution: Some rechargeable appliances may damage the Power Inverter or the
appliance. When first using a rechargeable device, check the inverter's tem-
perature for the first 10 minutes. If it becomes abnormally hot, do not use this
device with the Inverter.
2. Flip the Power Switch to the ON position to turn on. Do not use the appliance
until the power LED illuminates.
3. Turn on appliance. If an alarm sound is heard, turn off the appliance.
Caution: It is recommended that the vehicle be started every hour to recharge
the battery. Doing this will help prevent any unexpected shutdown of the equip-
ment. This will also help ensure that there will be enough battery power to start
the vehicle. Due to the risk of carbon monoxide inhalation (see Warning # 22 on
page 4), do not run the vehicle's engine within an enclosed area.
4. After use, disconnect the appliances and flip the Switch to the OFF position.
1. Keep this unit clean and dry. Unplug the unit before cleaning. Clean only the
outside of this unit with a soft, dry cloth; never clean this unit with water or harsh
cleaners.
2. Aside from the fuses, this device does not contain any user replaceable parts.
If it needs service, take it to a qualified technician.
3. Fuse Replacement:
This unit must have all energy storing electronics discharged BEFORE
opening; test for voltage to verify that the unit is safe BEFORE opening.
Remove the screws holding on the front plate. Slide it up slightly to allow the
bottom plate to slide out. Using insulated pliers (sold separately), remove, check,
and replace* each fuse as needed. Reverse the earlier steps to reassemble.
*Replace each fuse ONLY with another 30 amp, blade-type fuse.
SKU 93761 For technical questions, please call 1-800-444-3353.
FRONT

Operation

Maintenance

Outlets
Page 6