Related Manuals for UEi C50
Summarization of Contents
Controls and Indicators
Display Controls
Describes physical controls like buttons and rotary selector.
Accessory Components
Describes components like particle filter and water trap.
Main Display Parameters
Key parameters shown on the analyzer's display.
Operating Instructions
Before Use Each Time
Pre-operational checks for the analyzer.
Parameter Descriptions
Details on CO/CO2 ratio, battery, date, and time display.
Setting Inlet Temperature
Sampling the Flue Gas
Guidance on where and how to insert the probe.
Changing the Display
Display Parameter Selection
How to change parameters on the first and lower display lines.
Menu Navigation and Settings
Set Time
Procedure to set the instrument's time.
Date Settings
Procedure to set the instrument's date format and value.
Top Line Data
How to change information displayed on the top line.
Temperature Units
Setting temperature units between Celsius and Fahrenheit.
Display Contrast
Adjusting the display contrast level.
Fuel Selection
Selecting the type of fuel being analyzed.
Language Settings
Choosing the display language.
Print Header Setup
Setting custom header text for printouts.
Data Storage
Saving and deleting test results from memory.
Oxygen Reference Setting
Setting a reference oxygen value for readings.
Measurement Units and Service
Efficiency Calculation Modes
Selecting Gross, Net, or Condensing efficiency calculation.
CO Measurement Units
Selecting units for CO measurement (PPM or mg/m³).
Service Mode Access
Information regarding service mode and firmware display.
Storing Test Results
How to store readings in memory.
Printing Test Data
Printing A Test
How to print test data on demand.
Combustion Theory and Calculations
Combustion Theory Basics
Explains the process of combustion and its ideal conditions.
Efficiency Calculation Factors
Identifies sources of loss affecting fuel burning efficiency.
Efficiency Calculation Formulas
Provides formulas for calculating combustion efficiency.
Gas Measurement Interpretation
Oxygen Reference Explanation
Explains the meaning and use of oxygen referencing.
CO Air-Free Conversion
Calculates CO concentration adjusted for air-free conditions.
CO Conversion to mg/m³
Formula to convert CO readings from ppm to mg/m³.
Maintenance and Troubleshooting
Periodic Service Guidelines
Recommendations for instrument calibration and care.
Cleaning Procedures
Instructions for cleaning the instrument case.
Battery Replacement and Charging
Guidance on battery types, installation, and charging.
In-line Water Trap Maintenance
Steps for emptying and cleaning the water trap.
Particle Filter Replacement
Importance and procedure for changing the particle filter.
Troubleshooting and Specifications
Annual Re-Calibration
Recommendation for annual analyzer re-calibration.
Common Faults and Causes
List of common problems and their potential causes.
Electromagnetic Compatibility
Information on EMC compliance and interference mitigation.
Instrument Specifications
Technical specifications for temperature and gas measurements.
Need help?
Do you have a question about the C50 and is the answer not in the manual?
Questions and answers