MANUAL OPERATION OFFICE PRO 36 READ THIS MANUAL CAREFULLY FOR INSTRUCTIONS ON CORRECT IN- STALLATION AND USAGE, AND READ ALL SAFEGUARDS. US LISTED...
Page 2
All rights reserved. This book may not be reproduced or copied, in whole or in part, without the written permission of the publisher. DENSO SALES CALIFORNIA, INC. reserves the right to make changes without prior notice. MovinCool is a registerd trademark of...
• The Offi ce Pro 36 is equipped with a six (6) foot (1.8 meter) AFCI power cord. If replacement, fi xed location (hard wired) or power cord lengthening (extension cord) cords are required, contact your reseller or a qualifi...
Do not install the unit in sloping areas. The unit may move or topple over even if the casters are set to the LOCKED position. • Install the unit in areas that can withstand the weight of the unit. The Offi ce Pro 36 weighs approximately 440 lbs (200 kg). •...
Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign mat- ter. • The Offi ce Pro 36 model is equipped with an approved NEMA plug confi guration (6-30). The appropriate outlet must be used for this plug type. FRONT AND BACK HANDLES...
FEATURES OP36 Features • An electronic control panel which allows the user to control the unit’s operation easily. • Dual fan speeds (either High or Low) in both COOL and Fan Only modes. • A digital display that indicates the Temperature SET POINT (either Fahrenheit or Celsius) in which the COOL Mode will operate.
After the COOL mode has been activated, the unit cannot be turned off by pressing the fan buttons. The COOL ON/O FF button must be pressed. FF button must be pressed. SET TEMP CLOCK/TIMER FAN ON/OFF START TIME END TIME SET CLOCK COOL ON/OFF PROGRAM Office Pro 36...
How to Set a Program Setting a START TIME ➀ Press the Program SET button. The Program SET button and START TIME LEDs will illuminate. Press the HRS and MIN buttons to set the START TIME. Setting an END TIME ➁...
Operating Modes Offi ce Pro 36 operates in 2 modes, FAN Only and COOL. When in FAN Only mode, the unit circulates the surrounding air. When in COOL mode, the compressor is operational and cool air is circulated. • COOL Mode Offi...
fi rst press the Program RUN button. Remove the 2 air fi lters. ➁ NOTE: To remove the fi lters from the Offi ce Pro 36, open the front panel and side panel fi lter doors. Unclip the wire frame and remove fi lter. CLIP...
➄ Empty all water from the drain tank. ➅ TROUBLESHOOTING Offi ce Pro 36 Self-Diagnostic Codes Self-Diagnostic Codes will be displayed on the Control Board under the following conditions: Note: If AS does not disappear from display, contact your distributor.
Check the following points before calling a qualifi ed technician. SYMPTOM SYMPTOM SYMPTOM Unit does not operate Insuffi cient cooling If symptoms persist after the above actions have been taken, turn the unit off, disconnect the power cord plug and contact your MovinCool reseller. AFCI Power Cord Manual WARNING: The AFCI device is a non-serviceable part.
Control Device temperature control temperature control programmable timer programmable timer two speed fan two speed fan OFFICE PRO 36 OFFICE PRO 36 95º F (35º C) 95º F (35º C) 83º F (28.2º C) 83º F (28.2º C) 60Hz 60Hz...
Products such warranty shall be for a period of thirty six (36) months after delivery to the end-user. DENSO shall, at its sole option, repair or replace any defective Product covered by this warranty.
Page 16
DENSO SALES CALIFORNIA, INC. 3900 Via Oro Avenue Long Beach CA 90810-1868 800-264-9573 / 310-834-6352 www.movincool.com First Issue: March 2005 DSCA P/N: LA484007-1810 Printed in the U.S.A.
Need help?
Do you have a question about the 36 and is the answer not in the manual?
Questions and answers