ZENEC ZE-MR1020-DVD Instruction Manual page 36

4. Pull out the original dome light power wire and signal/power cable through the original
dome light opening.
5. Connect RCA input and output cables.
6. Connect the wire harness in the following order: ground wire, battery wire, ACC wire and
door wire.
7. Fix the monitor to the metal mounting plate using the CM 4x8 screws.
Four CM 4x8 screws
8. Mount the cover of the LED dome lights.
9. Please test all functions of the unit again.

notES:
■ Do remember to connect the red wire to the ACC of the ignition switch. Otherwise the
battery charge might be drained off prematurely.
■ If the fuse is opened, first make sure that the cables have not caused a short circuit, and
then replace the old fuse with a new one of the same ratings.
■ Do not have unconnected cables or terminals touch the metal on the car or any other
conducting material.
■ To prevent short circuits, do not remove the caps from unused terminals or from the
ends of the unconnected cables.
■ After the display unit is installed, check and make sure the brake lights, blinkers, wiper,
etc. on the vehicle are working properly.
■ Insulate unconnected wires with vinyl tape or other similar material.
36