ZENEC ZE-MR1020-DVD Instruction Manual page 34

1. battery + (yellow)
■ To be connected to the positive terminal of the car battery.
2. Acc power (red)
■ To ACC power lead powered when engine key position is ACC.
3. ground (black)
■ Connect the lead to a good chassis ground on the car. Make sure the connection is
made to bare metal and is securely fastened, using the sheet metal screw provided.
4. Door wire
■ This wire should connect to the door sensor of car. Then the dome light can be switched
by opening or closing door.
5. AuX A/V, input 1
6. AuX A/V, input 2
7. AuX A/V, output
■ An auxiliary A/V output is provided to drive an external monitor. This signal mirrors
what's being shown on this player. The volume function does not affect the auxiliary A/V
output.
8. polarity switch
■ Please slide to "–" at the left position if your vehicle's power supply system of the door
contact switch is negative.

notE:
1. Please slide it completely to one side.
2. Do not slide this switch after placing it at a position. Otherwise, it'll be damaged.
■ Please slide to "+" at the right position if your vehicle's power supply of the door contact
switch system is positive.
9. Slot for SD/mmc/mS AnD uSb
34