Adjusting The Folding Position; Adjusting Folding Width - Ricoh Aficio MP W3600 Operating Instructions Manual

Functions of the Folding Finisher

Adjusting the folding position

You can adjust folding widths for Fan fold, and margins for Fan fold (Margin Fold).
Note
❒ The folding position can be adjusted using either the Folding Finisher or the
printer. Settings configured with the Folding Finisher are applied when folding
2 paper in offline mode. Settings configured with the printer are applied when
folding paper in online mode.

Adjusting folding width

This section explains how to adjust folding widths, using the example of fan-folding
paper three times to make four surfaces.
If you adjust the folding width n 0.05 inches, the size of each surface is adjusted
as follows:
1st surface
2nd surface
3rd surface
4th surface
The last surface will be shorter than the other surfaces, since the length of the
other surfaces has increased.
Note
❒ Folding position adjustment is applied to all fold types and surfaces. However, a
folding width cannot be set to less than 8
width for Fan fold is 8
❒ For the procedure to configure settings using the Folding Finisher, see
"Changing the Folding Finisher Settings".
❒ When configuring settings using the printer, use the system setting "Fold Width
Fine Adjustment". For the procedure to configure settings using the printer, see
General Settings Guide manual of the printer's operating instructions.
Reference
p.39 "Changing the Folding Finisher Settings"
22
Before adjustment
A inch
B inch
C inch
D inch
1
/ inches.
2
After adjustment
A n 0.05 inches
B n 0.05 inches
C n 0.05 inches
D o 0.15 inches
ATS035S
1
/ inches, since the minimum folding
2