US Robotics 56K MESSAGE MODEM - QUICK INSTALLATION GUIDE FOR WINDOWS Quick Installation Manual page 15

click the description of your new modem or Standard Modem if there is no
specific description, then click the Driver tab. Click Update Driver. Click Next.
Select Search for a suitable driver for my device. Click Next. Select Specify a
location. Click Next. Select CD-ROM drive. Click Next. Select Install one of the
other drivers, then click Next. Select U.S. Robotics 56K Message V.92. Click
Next. A Digital Signature Not Found message will appear. Click Yes. Click Finish
to complete the installation.
If you have Windows XP:
Windows XP users must be in administrator mode to properly add any
new hardware. Your modem will be automatically installed. Follow the
update driver procedure below.
Turn your computer on. Insert your Installation CD-ROM into your CD-ROM drive.
Click Start then click Control Panel. If you are not in Classic View, switch to
Classic View now by clicking the selection in the upper-left corner of your screen.
Double-click the System icon. Click the Hardware tab. Click Device Manager.
Expand Modems by clicking +. Double-click the description of your new modem
or Standard Modem if there is no specific description, then click the Driver tab.
Click Update Driver. Select Install from a Specific Location (Advanced). Click
Next. Select Don't search. I will choose the driver to install. Click Next. Click
Have Disk. Type the letter of your CD-ROM drive and a colon (D: if your drive
letter is D). Click OK. Select the description of your modem, then click Next. If you
see a warning telling you that this modem has not passed logo testing, click
Continue Anyway. Click Finish.
All Windows Operating Systems:
V.92 Features
Would you like to install the ControlCenter software?
The ControlCenter software allows you to configure your V.92 modem settings
and automatically notifies you of any updates to your modem's code.
• To install the ControlCenter software, eject and reinsert the Installa-
tion CD-ROM into your CD-ROM drive. If the Installation CD-ROM inter-
face does not run automatically, click Start and then click Run. In the
Run dialogue box, type D:\setup.exe. If your CD-ROM drive uses a dif-
ferent letter, type that letter in place of D.
3