US Robotics 56K MESSAGE MODEM - QUICK INSTALLATION GUIDE FOR WINDOWS Quick Installation Manual page 20

looking power supplies may be of different voltages and could damage your
modem. When your modem is properly connected to an electrical outlet, a wall
outlet, or a surge protector and is turned on, the CS light on the front panel will
be illuminated.
Possible solution:
Windows XP, 2000
You may not have the correct modem type selected in your software or in
Windows. Click Start, Settings (Windows 2000 only), and then Control Panel.
When Control Panel opens, click Phone and Modem Options. Click the Modems
tab. Here you will see a list of installed modems. You can also add, remove, or
view the properties of modems from this window. The U.S. Robotics modem you
have installed should be present in the list of installed modems. If none of the
modem descriptions in the list matches your U.S. Robotics modem or no
modems are listed, your modem is not properly installed. Try reinstalling your
modem using the instructions on this Guide for your operating system.
Windows Me, 98, 95, NT
You may not have the correct modem type selected in your software or in
Windows. Click Start, Settings, and Control Panel. When Control Panel opens,
double-click Modems. Here you will see a list of installed modems. You can also
add, remove, or view the properties of modems from this window. The U.S.
Robotics modem you have installed should be present in the list of installed
modems. If none of the modem descriptions in the list matches your U.S.
Robotics modem or no modems are listed, your modem is not properly installed.
Try reinstalling your modem using the instructions in this Guide for your
operating system.
Possible solution:
Windows XP
If you are using Dial-Up Networking, it may not be configured correctly. Check
your configuration and make sure you have the correct port selected. Click Start,
Control Panel, and double-click Network Connections. Double-click the
description of the dial-up networking connection, and select Properties. Make
sure that the description in the Connect Using box (under the General tab)
matches the description of the modem you are using. If it doesn't match, select
the proper modem description.
Windows 2000
If you are using Dial-Up Networking, it may not be configured correctly. Check
your configuration and make sure you have the correct port selected. Click Start,
point to Settings, and click Network and Dial-up Connections. Make sure that
the description in the Connect Using box (under the General tab) matches the
description of the modem you are using. If it doesn't match, select the proper
modem description.
8