Miele PT 7136 Operating And Installation Manual page 27

What if ...
At the end of a
program
Clean filter or
Clean the lint filter
appears
Clean out airways
Program finish
time changed
Possible cause
The dryer reminds you to
clean the lint filter.
The cycle of the "Clean
filter" message can be
adjusted.
The dryer does not work
at its optimum or not
efficiently.
Possible cause:
clogging by lint or
detergent residues.
The exhaust duct may
be very long. This is not
a fault.
This is not a fault.
Frequently asked questions
Solution
– Remove and clean the lint filter.
To delete this message:
– Confirm with "OK".
– See "Settings - Supervisor level
- Cleaning the lint filters".
– Check all possibilities as
described under "Other faults -
The program runs too long or
stops".
To delete this message:
– Confirm with "OK".
With a long exhaust duct, program
times and energy consumption
increase.
The "Clean out airways" message
cycle can be adjusted.
– See "Settings - Supervisor level
- Cleaning the airways".
While the timer was counting
down, the settings were changed
or there was a power failure.
27