Miele PT 7136 Operating And Installation Manual page 14

Use
Remaining time
When a program is selected, the
approximate duration is displayed. This
is the "remaining time".
The program duration can vary due to
some factors: residual moisture after
spinning, fabric, load size, room
temperature and voltage fluctuations.
The adaptive electronic adjusts to the
individual load to display the accurate
remaining time. The remaining time is
constantly checked which can lead to
leaps in time.
The "Woolens handcare" and
"Smoothing" programs can be ended
ahead of time once a certain
temperature is reached. This may be
the case with fine fabrics or if the dryer
had some residual heat from a previous
program.
Before the end of a program
After drying with hot air, the cool down
phase finishes the program. "Cooling
down" is displayed. Only after the
cooling phase has ended is the
program finished.
The programs: "Woollen handcare" and
"Smoothing" do not have a cooling
down phase.
14
7. At the end of a program
"Anti-crease" (if selected) and "End"
mark the end of a program in the
display. During the anti-crease phase
the drum will turn in intervals if the
laundry is not immediately removed
from the dryer to prevent the laundry
from wrinkling. Run time 1 h.
Use the button to open the drum
door.
Remove the laundry.
Check the drum for any missed
pieces of laundry. Any items left in
the dryer can be damaged because
of over-drying.
If the door stays open, the light goes off
after a few minutes (saving energy).
Close the door.
Cleaning and care hints
See "Cleaning and Care".